Car Starts Sometimes but Not Others? 8 Causes of an Intermittent No-Start

When your car starts sometimes but not others, the problem is almost never truly random. Intermittent no-starts usually follow a pattern: only when the engine is hot, only on cold mornings, only after a short stop, or only when the shifter is in a certain spot. Spotting that pattern is the fastest way to the cause, and it can save you from paying a shop to replace parts that work fine on the day you bring the car in.

Driver trying the ignition again because the car starts sometimes but not others

Quick answer: match the pattern

When it won’t startMost likely cause
After a short stop, when the engine is hotCrankshaft position sensor, starter heat soak, or a weak fuel pump
Cold mornings onlyWeak battery or corroded connections
One click, then it works after a few triesStarter with a dead spot, or a loose cable
Starts if you jiggle the shifter or try NeutralNeutral safety switch (range sensor)
Security light flashes when it failsImmobilizer or key chip problem
Cranks normally but won’t fire, totally at randomFuel pump relay or crankshaft sensor

Why a car starts sometimes but not others

Every start depends on a chain of parts working at the same moment: the battery and its cables, the starter, the switches that say it’s safe to crank, the key recognition system, fuel delivery, and the crankshaft sensor that times spark and fuel. A part that’s failing rarely dies all at once. It works when conditions are easy and fails when they’re not, which is why heat, cold, and vibration so often decide whether the car starts.

8 common causes

1. Loose or corroded battery connections

This is the most common cause and the cheapest fix. A terminal that’s slightly loose or crusted with corrosion can pass enough current one day and not the next. Check both clamps for movement and clean any white or green buildup. Don’t forget the ground strap between the engine and the body.

2. A borderline battery

A battery that’s nearly worn out may start the car on warm afternoons and fail on cold mornings. A free load test at an auto parts store gives you a clear answer. If cold weather is the trigger, see car won’t start in cold weather.

3. A starter with a dead spot

As a starter motor wears, it can develop a dead spot where it stops on a worn section and won’t turn. You hear one click and nothing else. Try again a few times and it suddenly works. That pattern, especially if it’s getting more frequent, points to a starter on its way out.

4. Heat soak

Some starters, crankshaft sensors, and fuel pumps only fail when they’re hot. The classic sign is a car that starts fine in the morning but won’t restart after a 10-minute stop at the store, then starts again once it cools down.

5. A failing crankshaft position sensor

Without a signal from this sensor, the engine cranks normally but never fires. These sensors often fail when hot and recover when cool. A scanner may show a stored code such as P0335, which you can look up in our OBD2 code lookup.

6. Neutral safety switch out of adjustment

Automatic cars only crank in Park or Neutral. If the switch that confirms the gear is worn or misaligned, the car may only start when you wiggle the shifter or try Neutral.

7. A worn ignition switch

If the dash flickers when you turn the key, or wiggling the key changes anything, the switch’s contacts may be worn. If the problem is that the key itself sometimes won’t turn, see our guide to why a key won’t turn in the ignition.

8. Immobilizer or key problems

If the security light flashes when the car refuses to start, the car isn’t recognizing the key. Try your spare key, and replace the fob battery if you have push-button start.

How to track it down

  1. Keep a short log. Note the weather, whether the engine was hot or cold, what you heard (click, crank, nothing), and what finally made it start.
  2. Test when it fails, not when it works. Listen for the fuel pump’s two-second hum with the key in the ON position. Watch whether the dash lights dim when you try to crank. Note the security light.
  3. Scan for codes after a failure. Even without a check engine light, the computer may have stored a code.
  4. Don’t keep cranking. Limit tries to about 10 seconds, with 30 seconds of rest between them, so you don’t overheat the starter.

If the car never cranks at all and the dash lights still work, our guide to car won’t start but lights work covers that pattern in more detail.

Car starts sometimes but not others: repair costs

RepairTypical cost
Clean and tighten terminals$0–$20
Key fob battery$3–$10
Fuel pump relay$20–$100
Battery cable or ground strap$50–$250
Neutral safety switch$100–$300
Crankshaft position sensor$120–$350
Ignition switch$150–$400
Starter motor$300–$700
Fuel pump$450–$1,100

Before replacing a starter or ignition switch, enter your VIN in the NHTSA recall lookup. Ignition and starting problems have been covered by recalls on some models.

Can I keep driving?

You can, but plan around it. An intermittent no-start tends to get worse over time and usually fails at the worst possible moment. Until it’s fixed, avoid long trips, park where you could get help or a jump if needed, and don’t shut the engine off somewhere you can’t afford to be stuck. If you notice that the problem only happens when hot, give the engine a little longer to cool before you leave it parked on a quick errand.

If a new battery and clean terminals didn’t fix it, read car won’t start but battery is good, and if the battery keeps going flat, see car battery keeps dying. Still not sure? Our free car symptom checker can help you narrow it down.

Free tools from GarageWise HQ

Car Symptom Checker: not sure what's wrong? Answer two quick questions to narrow it down.

OBD2 Code Lookup: got a check engine code? See what it means and what the fix usually costs.

About the author: Muhammad Umair Naseer

Muhammad Umair Naseer is the founder and editor of GarageWise HQ. A software engineer by training, he started the site to turn confusing car problems into clear, practical guides. Every article is researched from owner's manuals, manufacturer service information, and trusted repair resources, and when a job needs a certified mechanic, he says so.